Hello,
J' have a problem with detection anti-pinching.
A signal of 12 Volt modulated in PWM.
J' placed in Parallel a small resistance network with the recovery of the tension towards the Moteur exit.
I thus recover well this signal decreased with 4,7 Volts (crenels maximum) in analogical entry on A0.
Only I n' do not arrive has well to configure the functions of
- adc. Read (0) or - ReadMean, setfreq.
Because normally, if I block the engine with the hand, l' intensity the beam becomes more important!
Here my configuration for a Quartz with 20 MHz. ADC.SetAcqTime (11) ADC.SetConvTime (FOSC_32). Anybody could it m' to help?
detection anti-pinching
Moderators: David Barker, Jerry Messina
detection anti-pinching
My first interest is working with a PWM signal.
Motor : 24 Volts 4 or 5 A.
Motor : 24 Volts 4 or 5 A.
Detection anti-pincement / sortie Moteur avec un signal PWM
Bonjour,
Un signal PWM est injecté sur un moteur forcé manuellement à l'arrêt..
J'ai placé un réseau de résistance sur cette sortie moteur pour obtenir ce même PWM signal de 12 V ----> +0 - 5 Volts.
Si je bloque le moteur manuellement, je dois avoir une intensité traversant la bobine du moteur (P = U * I) plus importante.
Seulement quand j'Analyse le Spectre du signal pendant cette phase, je ne detecte aucun chagement du signal car, normalement, la moyenne des crêtes (volt) diminue en sortie du moteur puisque la puissance dissipée reste constante d'où : si P reste constant = I > et U <.
D'avance merci pour votre réponse.
Cordialement, Stéphane.
Un signal PWM est injecté sur un moteur forcé manuellement à l'arrêt..
J'ai placé un réseau de résistance sur cette sortie moteur pour obtenir ce même PWM signal de 12 V ----> +0 - 5 Volts.
Si je bloque le moteur manuellement, je dois avoir une intensité traversant la bobine du moteur (P = U * I) plus importante.
Seulement quand j'Analyse le Spectre du signal pendant cette phase, je ne detecte aucun chagement du signal car, normalement, la moyenne des crêtes (volt) diminue en sortie du moteur puisque la puissance dissipée reste constante d'où : si P reste constant = I > et U <.
D'avance merci pour votre réponse.
Cordialement, Stéphane.
My first interest is working with a PWM signal.
Motor : 24 Volts 4 or 5 A.
Motor : 24 Volts 4 or 5 A.
Also Thank's, it's not have been with not courage !
Danke ![/quote]
My first interest is working with a PWM signal.
Motor : 24 Volts 4 or 5 A.
Motor : 24 Volts 4 or 5 A.